Contact us if document is not available

Show all documents

Sika® Antisol®-107

(former MKure 107)

Water based concrete curing compound, white pigmented for solar reflectance

Sika® Antisol®-107 is a solvent free, membrane forming wax emulsion, suitable for spray application to freshly poured concrete.
The resultant film retains sufficient moisture in the concrete to ensure full hydration of the cement, essential for optimum strength development. Membrane cured concrete is typically harder and exhibits a dust free surface with a reduced incidence of drying shrinkage cracks. Sika® Antisol®-107 incorporates a white pigment which at recommended coverage rates gives a daylight reflectance value of 60 - 80 %. This permits a high curing efficiency to be maintained even in conditions of intense ambient light. Suitable for use in hot and tropical climatic conditions.

Sika® Antisol®-107 has the following characteristics:
  • Water based
  • Solar reflective
  • Single application
  • Reduces incidence of plastic cracking
  • High curing efficiency
  • Ensure achievement of desired strengths, minimize shrinkage
  • Alleviates other costly methods such as Hessian – watering
  • Promotes a harder dust free surface
  • Considerable reduction in loss of water from concrete
  • Cured film is clear and water repellent.
Inquire Now

Contact us if document is not available

Show all documents

Usage

Sika® Antisol®-107 is suitable for all kinds of concrete, horizontal and vertical applications and large areas of exposed concrete, such as:
  • Highways
  • Runways and taxiways
  • Aprons and hard standings
  • Roof decks
  • Pre-stressed beams and piers
  • Irrigation canals / channels
 

Advantages

Sika® Antisol®-107 has the following characteristics:
  • Water based
  • Solar reflective
  • Single application
  • Reduces incidence of plastic cracking
  • High curing efficiency
  • Ensure achievement of desired strengths, minimize shrinkage
  • Alleviates other costly methods such as Hessian – watering
  • Promotes a harder dust free surface
  • Considerable reduction in loss of water from concrete
  • Cured film is clear and water repellent.

Packaging

Cans and drums

Colour

White milky liquid

Product Details

Sustainability / Certifications / Approvals

CERTIFICATES AND TEST REPORTS

Sika® Antisol®-107 follows the requirements of ASTM C 309; Type 2; Class A
Product Information

Composition

Parrafin wax

Shelf life

12 months from date of production if stored properly

Storage conditions

Store in undamaged, unopened, original sealed packaging in dry conditions at temperatures between +5°C and +50°C. Protect from direct sunlight and frost.

Density

~0.95 kg/l (+25°C)

Application

Consumption

Consumption

~5–6 m2/l 
The rate of coverage depends on wind speed, relative humidity, temperature conditions and surface profile of the concrete.

This corresponds to that at which Sika® Antisol®-107 has been tested, and at which it attains the claimed degree of curing efficiency. In favourable conditions such as shaded interior surfaces, adequate curing can be achieved with extended coverage rates.
Application steps

SUBSTRATE PREPARATION

It is essential to dampen down the concrete with clean water prior to application, to assist in the breakdown of the Sika® Antisol®-107 film on vertical and formed surfaces.

APPLICATION

Sika® Antisol®-107 should be spray applied as evenly as possible on to the freshly placed concrete. Stir Sika® Antisol®-107 well before use.
For horizontal surfaces Sika® Antisol®-107 should be applied as soon as the initial surface sheen has disappeared from the concrete surface. In the case of formed concrete, the Sika® Antisol®-107 should be applied immediately on removal of the formwork.

Documents