Sikacrete®-2702 3D

Portland cement, selected aggregates and additives

6 months from date of production

The product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +30 °C. Always refer to packaging.

~1 mm

~2.2 kg/l (25 °C)

~10 – 50 mm (subject to trials)

+5 °C min. / +45 °C max.

16 % – 19 % water + 1 % SikaRapid®-2702 3D (by weight of powder)

~13.4 L / 25 kg bag

(for mixing ratio: w/p = 0.18)

Static Mixers (Small volume quantities)
Mix with an electric single or double paddle mixer (<500 rpm) or using a forced action mixer capable of mixing 2 to 3 bags at a time.
Add the recommended amount of clean water in a suitable mixing container. Stir slowly, add the powder to the water and mix thoroughly for a minimum of 3 minutes. Add more water during the mixing time if necessary to the maximum specified amount to achieve a smooth consistent mix. If necessary and before pumping, let the material stand to allow the air bubbles from entrained air to finish. Stir gently if required.
Continuous Mixer (High volume quantities)
The mixing ratio shall be determined using a pan test heating method or microwave technique (according to Austrian Standard) to determine the equivalent flowrate/m³ on the equipment. Contact Sika Technical Services for additional information.

Pumping and printing is usually a continuous process. The application specifics of the extrusion and printing speed must be optimised between the mixer, pump, pump line length and printer head.

SikaRapid®-2702 3D should be used as an accelerator for set ups which can accommodate an accelerator at the printer head. For more information about which accelerator would be more appropriate, please consult our Sika technical department.

When printing, it is recommended to cure the finished printed element with a suitable Sika® Antisol® curing agent.

Clean all tools and application equipment with water immediately after use. Hardened material can only be removed mechanically.