Sikafloor®-2200 ADH

Epoxy resin filled with fine aggregates

12 months from date of production

Store in original, unopened, sealed and undamaged packaging in dry conditions at temperatures between +5°C and +35°C. Protect from direct sunlight, heat and moisture.

~1,77 kg/l (at 25°C)

Adhesion to concrete is higher than it's cohesive strength

Sikafloor®-2200 ADH has very good resistance to the following: most aqueous systems, sewage, urine, fresh water, sea water, diluted and concentrated alkalis, diluted acids, sulphur gases, mineral, vegetable and animal oils and fats, ammonia and formaldehyde.

5 mm max.

+5°C min. / +45°C max.

Note: The potlife begins when the resin and hardener are mixed. It is shorter at high temperatures and longer at low temperatures. The greater the quantity mixed, the shorter the potlife. To obtain longer workability at high temperatures, the mixed adhesive may be divided into portions. Another method is to chill components A and B before mixing them (not below +5°C).

Note: Times are approximate and will be affected by changes in ambient conditions, particularly temperature and relative humidity.

As a guide:

1. ~1.77 kg/m² per mm of thickness.
2.  7.5 kg unit is sufficient to cover ~2.8 m² at 1.5 mm thickness.

Note: These figures are theoretical and do not include for any additional material required due to surface porosity, surface profile, variations in level or wastage, etc.

Substrates must be sound, dry, clean and free from laitance, ice, standing water, grease, oils, etc. Old surface treatments or coatings and all loose or friable particles must be removed to achieve a laitance and contaminant free, open textured surface. Avoid dew point conditions.

The 7.5 kg pack has been designed to be readily mixed by trowel. Where more than one pack is to be mixed at a time, a slow speed mixing drill and sealant paddle is suitable. Mix until a smooth streak free consistency is achieved. Avoid aeration while mixing. Mix only the quantity which can be used within product pot life.

Apply Sikafloor®-2200 ADH by spatula or trowel to the required level, using the minimum of solvent on the trowel to aid workability. The surface may be finished smooth by use of a paint brush dipped in a suitable thinner (Xylene / MEK / Acetone). Where a very deep recess is to be filled, it may be necessary to build up in layers. Repairs may be camouflaged if required by covering surface with cement powder before full cure is affected.

Clean with a suitable thinner (Xylene / MEK / Acetone) immediately after use. Hardened / cured material can only be mechanically removed.