SikaBond® DV

• SikaBond® DV is certified according "Low Emitting Materials as per Al Sa'fat - Dubai Green Building Evaluation System" by Dubai Central Laboratory (DCL) certificate No. CL17020432

• SikaBond® DV follows the requirements of ASTM C1059 for Type II for bonding fresh to hardened concrete, when applied as a bonding slurry.

Styrene Butadiene Rubber 

12 months minimum from production date

Store in a dry area in original packaging and at temperatures between +5°C and +35°C. Protect from direct sunlight, heat and moisture.

~1.00 kg/l (+25°C)

BONDING SLURRY FOR FRESH TO OLD CONCRETE:

SikaBond® DV : Ordinary Portland Cement (OPC) = 1 : 2

Note: Trial mixes must be performed to establish the exact dosage rate required. For optimum results, always ensure that the correct SikaBond® DV : Water ratio is used.

MORTARS AND RENDERS:

Trial mixes must be performed to establish the exact dosage rate required. For optimum results, always ensure that the correct SikaBond® DV : Water ratio is used. Depending on the application and performance required, SikaBond® DV may be added to the clean mixing water within the range of 1:1 to 1:2. For all applications, apart from sprayed on renders, a bonding bridge should be brushed into the prepared surface.

Note: The above mixes are for guidance only and based on the use of sharp, well graded aggregates and dry sand.

BONDING SLURRY:

Mix together with fresh cement to a homogeneous brushable slurry consistency. The resulting bonding slurry should be brushed well onto the prepared surface.

MORTARS AND RENDERS:

Mixing can be done in any suitable concrete mixer, such as a pan mixer. First add the cement and aggregate into the mixer and mix to a uniform consistency. Then add the required quantity of SikaBond® DV and mix slowly for at least 2 minutes. Apply by steel trowel and finish with a wooden float.