Product Data Sheet Show all documents

SikaRep® Fine SA

ONE COMPONENT, ECONOMICAL, POLYMER MODIFIED, PORE SEALER / FINISHING MORTAR

SikaRep® Fine SA is a cementitious, silica fume containing, polymer modified one component pore sealer and finishing mortar. Suitable for use in hot and tropical climatic conditions.

  • Easy to use
  • Excellent workability
  • Good mechanical strengths
  • Can be applied by the wet-spray method
  • Non-corrosive
  • Adjustable consistency
  • Economical
Product Data Sheet Show all documents

Usage

SikaRep® Fine SA can be used as a:
  • Pore sealer / finishing mortar on cementitious substrates.
  • Thin layer rendering on horizontal and vertical areas in building and civil engineering construction, for external and internal finishing etc.
 
  • Levelling mortar on uneven substrates, and profiled concrete surfaces.
  • Repair mortar to fill honeycombing pores etc.
  • Repair mortar for repair of small defects on edges and joint sides; to form and finish joints and covings.

Advantages

  • Easy to use
  • Excellent workability
  • Good mechanical strengths
  • Can be applied by the wet-spray method
  • Non-corrosive
  • Adjustable consistency
  • Economical

Packaging

25 kg bag

Colour

Grey Powder

Product Details

Product Information

Composition

Polymer containing cementitious mortar with different additives.

Shelf life

12 months minimum from production date

Storage conditions

Store in undamaged, unopened, original sealed packaging in dry conditions at temperatures between +5 °C and +35 °C. Protect from direct sunlight, heat and moisture.

Maximum Grain Size

~0.15 mm
Technical Information

Compressive Strength

7 Days

28 Days

w/p ratio = 0.3, 7.5 L per 25 kg bag

≥ 5 N/mm2

≥ 10 N/mm2

Application

Application Information

Mixing Ratio

7.0 - 7.5 litres of water per 25 kg bag

Fresh Mortar Density

~1.65 kg/l (25 °C)

Layer Thickness

Min. 1.0 mm

Max 2.0 mm in one single layer

Ambient Air Temperature

Min. +5 °C / Max. +40 °C

Substrate Temperature

Min. +5 °C / Max. +40 °C

Pot Life

~35 min (25 °C)
Consumption

Yield

~19.3 L per 25 kg bag
Application steps

MIXING

Mix 25 kg bag with the necessary, above mentioned, amount of cold water, using an electric blender with a suitable mixing spiral, in a clean bucket. Add the SikaRep® Fine SA powder slowly while mixing continuously for at least 3 minutes and until a homogeneous consistency is achieved.
Use a blender at 500 rpm maximum; do not mix at faster rate because of mechanical strength decay of the cured product. The obtained mix results very creamy, easily spreadable and thixotropic.

APPLICATION

SikaRep® Fine SA can be applied by trowel or spatula. As soon as the mortar has started to set it can be smoothed by wooden or synthetic float, styrofoam block or sponge. No additional water must be used as it may lead to surface discoloration.

 

CURING TREATMENT

Where ambient conditions may lead to rapid surface drying, the use of light water fogging for 48 hours or application of a suitable water based curing compound like Antisol®-WB is recommended. Do not commence fogging until final set has been reached.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with water immediately after use. Hardened / cured material can only be mechanically removed.

Documents