SikaGrout®-114 SA

Follows the CRD-C621-83-10.2 and ASTM C1107 as Type C

Portland cement, selected fillers and aggregates, special additives

12 months minimum from date of production

Store in original unopened packaging in cool and dry condition between 5 °C and 35 °C. Protect from direct sunlight, heat and moisture.

Max. 4 mm

~2.4 kg/l (25 °C)

Min. 10 mm per pour
Max. 100 mm per pour

+5 °C min. / +35 °C max.

+5 °C min. / +35 °C max.

~4 h (23 °C)

~11.7 L / 25 kg bag, depending on water addition

Add water according to the desired consistency into a clean mixing vessel before slowly adding the SikaGrout®-114 SA powder. SikaGrout®-114 SA is best mixed in a forced action mixer, for 2 to 3 minutes or until the mix is free of lumps, not longer than 5 minutes. Slow speed drill (maximum 500 rpm) can be also used for mixing. Normal tumble type concrete mixers are not suitable. Do not mix more grout than can be placed within 15 to 20 minutes. Do not add extra water or other ingredients. Mix only full bags for best results.

Before pouring let the mixed grout stand for approximately 5 minutes after mixing to allow entrapped air to escape. Pour into the prepared area such that the grout has the shortest distance to travel. Ensure that air displaced by the grout is allowed to escape. When carrying out base plate grouting, ensure a sufficient head of pressure is maintained to keep the mortar flowing. All exposed areas of the mortar surface should be kept as small as possible.

Treat exposed surfaces with Antisol®-WB curing compounds or use other approved curing methods such as polyethylene sheeting or wet hessian. Do not commence fogging until final set has been reached.

Clean equipment and mixer immediately after application with water. Hardened material can only be removed mechanically.