Product Data Sheet Show all documents

Sika® Igolflex®-619

(former MSeal 619)

Non-fibrated bitumen emulsion coating

Sika® Igolflex®-619 is a brown rubber/bitumen liquid emulsion with excellent adhesion which dries to a tough black seamless, flexible dampproof and vapourproof membrane.
Suitable for tropical and hot climatic conditions.

  • Vapour permeable allows substrate to breathe
  • Reduced chloride penetration due to hard impermeable surfaces
  • Simple and easy to use, no skilled labour required
  • Single component, use as supplied
  • Cold applied, no heating required
  • Non-slumping
  • Easy application due to paintable consistency, suitable for new and old concrete 
Product Data Sheet Show all documents

Usage

  • Protection and damp-proofing of concrete, asbestos cement sheets, roofing felts, wood.
  • Protection of steel work, pipes and metal.
 

Advantages

  • Vapour permeable allows substrate to breathe
  • Reduced chloride penetration due to hard impermeable surfaces
  • Simple and easy to use, no skilled labour required
  • Single component, use as supplied
  • Cold applied, no heating required
  • Non-slumping
  • Easy application due to paintable consistency, suitable for new and old concrete 

Packaging

20 L and 200 L drums 

Colour

Dark black/brown 

Product Details

Sustainability / Certifications / Approvals

CERTIFICATES AND TEST REPORTS

  • ASTM D2939
Product Information

Composition

Bitumen emulsion coating with 10 % rubber content.

Shelf life

12 months minimum from production date when stored properly in original, unopened, sealed containers.

Storage conditions

Store in undamaged, unopened, original sealed packaging in dry conditions at temperatures between +5°C and +35°C. Protect from direct sunlight, heat and moisture.

Density

~1.1 kg/l (at 25°C)

 

Application

Application Information

Substrate temperature

+5°C to +55°C

Waiting time to overcoating

6 - 8 hours per coat

Drying time

3 - 5 days
Consumption

Consumption

Typically, a coverage rate of 3 - 5 m2 / litre / coat (minimum 2 coats required) dependent on the substrate, porosity, texture and desired application.
Please contact Sika Technical Department for further information.
Application steps

SUBSTRATE PREPARATION

Sika® Igolflex®-619 may be applied to damp but not wet surfaces. During hot, dry weather application may be assisted by dampening the surfaces to be treated.

APPLICATION

  • Sika® Igolflex®-619 must be stirred well before use.
  • Where a single drum is used for prolonged periods, occasional stirring during application is recommended.
  • Apply evenly and in one direction using a stiff brush.
  • A minimum two-coat application is recommended to avoid possible gaps in the film.
  • Each coat must be allowed to dry before applying the next one at right angles to the first.
 

CLEANING OF EQUIPMENT

Clean all equipment and tools with water immediately after use. 

Documents