Contact us if document is not available

Show all documents

Sika MonoTop®-108 Water Plug AE

RAPID SETTING MORTAR

Sika MonoTop®-108 Water Plug AE is a rapid-setting cement mortar for plugging water leaks in concrete and masonry walls. Suitable for use in hot and tropical climatic conditions.

  • Rapid setting to avoid washout even in the presence of running water
  • Hardens within ~60–90 seconds (at 20 °C)
Inquire Now

Contact us if document is not available

Show all documents

Usage

  • Instant plugging of negative pressure water inlet through cracks, gravel niches and casting joints.
  • Instant plugging of drained water outlets, during waterproofing treatments.
 

Advantages

  • Rapid setting to avoid washout even in the presence of running water
  • Hardens within ~60–90 seconds (at 20 °C)

Packaging

6 kg plastic bag

Colour

Grey powder

Product Details

Product Information

Composition

Rapid-setting cement powder

Shelf life

6 months

Storage conditions

Store properly in undamaged original sealed packaging, in dry cool conditions.
Technical Information

Compressive strength

28 days

w/p ratio = 0.22

~32 N/mm2

Application

Application Information

Mixing ratio

1.2 liter of water per 6 kg bag

Ambient air temperature

+5 °C min. / +35 °C max.

Substrate temperature

+5 °C min. / +35 °C max.

Final set time

Temperature

Final Set Time

+20 °C

~90 seconds

+30 °C~60 seconds

Fresh mortar density

~2.13 kg/l (+23 °C)
Consumption

Yield

~3.5 litres per 6 kg bag
Application steps

MIXING

Depending on the site conditions and due to the rapid curing of the product only small quantities may be mixed at the time. Thoroughly and quickly mix the powder and water in a suitable container by gloved hand. Mix only the amount that can be immediately applied by gloved hand or trowel.

 

APPLICATION

Quickly work the mixed mortar firmly into the leaking crevice, V-cut, joint etc. and hold in place with a gloved hand or trowel until the mortar is sufficiently hard to remain in place. Strike off flush with the surface if desired. Repeat this procedure, mixing small quantities at a time until the seepage or leak is stemmed. If the water pressure is too high a timber plug maybe installed then covered with Sika MonoTop®-108 Water Plug AE.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with water immediately after use.
Hardened material can only be mechanically removed.

Documents