Sika develops and markets a complete range of admixtures and additives for use in concrete, cement and mortar production. These products enhance specific properties of the fresh and hardened concrete, such as workability, watertightness, durability, or early and final strength.

Michael Danzinger
"Sika admixtures can reduce CO2 emissions from concrete by half. They make a decisive contribution towards conserving nature and resources." Dr. Michael Danzinger, Corporate Technology Head Concrete Systems

Combining Sustainability and Performance

Extended workability, controlled over several hours, is especially important for urban construction sites with congested traffic, or remote areas resulting in long transportation times. At the same time, once the concrete is placed, fast curing is of utmost importance to meet tight construction schedules. Sika ViscoFlow® is a workability enhancing admixture, based on a new inhouse-developed polymer which significantly prolongs the workability time of the fresh concrete and still ensures equally fast strength development. The workability time can be modified in accordance to job site requirements.

Since more than a hundred years, Sika paves the way for progress in concrete solutions by developing and marketing admixtures and additives for use in concrete, cement and mortar production. Sika has the technologies to make this building material considerably more environmentally friendly.

Typical Application
Sika Solution Special Performance
Water Reducing Admixtures Sika® ViscoCrete® Highly efficient superplasticizer based on polycarboxylates
Workability Enhancing Admixtures Sika ViscoFlow® Newly developed PCE, enhancing the workability time significantly, allowing for the time needed to transport and to place the concrete properly
Shrinkage Controlling Admixtures Sika®Control Strong reductions in concrete shrinkage. Up to 40% is possible.
Cohesiveness enhancing Admixtures Sika® Stabilizer Increases overall mix cohesiveness without promoting concrete stiffening, which ultimately results in easier placement, reduced consolidation effort and improved aesthetics

Securing Quality for Concrete

Concrete is the most used building material in the world. Look at any infrastructure, tunnel, dam, parking lot, parking deck, or skyscraper. Any improvement in the engineering of concrete is a benefit for everyone. Improvements can include cost, strength, durability, or ease of application. And as the material evolves, our infrastructure becomes safer. However, concrete is a composite material: it is only as good as its weakest component. Sika admixture technologies are based upon the fact that the quality of raw materials and their respective properties vary widely and tend to weaken throughout the world. Sika technologies therefore aim to improve upon some of the known gaps in concrete as a composite material.

Durability Design of Concrete Structures Minimize Life Cycle Costs

As the cost of structures increases so does the need to keep these structures in service for as long as possible. This effectively reduces the life-cycle costs and aids in the investment decision from a time-value of money perspective. Limiting and preventing cracks protects the high alkaline environment that the concrete inherently creates. This, in turn, protects the reinforcement from corrosion. This is one of the most important attributes of concrete durability and one of the hardest to achieve consistently, but that is all about to change. A new shrinkage reducing/compensating admixture like Sika®Control SRA has the potential to generate a shrinkage neutral concrete, in other words, non-shrink concrete. High-performance concrete thus is not a single type of concrete, but rather, any number of concrete engineered to possess certain properties suitable for a particular construction application.

Get in touch with the Sika R&D Team