Contact us if document is not available

Show all documents

SikaCeram® WP Tape

(former MTile WP Tape)

SPECIAL WATERPROOFING TAPES / GASKET SYSTEM FOR CORNERS AND PERIMETER JOINTS, PIPE CULVERTS AND DRAINS

SikaCeram® WP Tape is a special polypropylene non-woven tape that is designed to reinforce and waterproof joints, corners, covers, angles, changes of plane, pipe penetrations and changes in material, as part of the Sikalastic® WP 668 waterproofing system.

  • Special polypropylene tape
  • Thin, non-woven, high-tenacity reinforcing tape
  • Crack-bridging, high security when cracks in the substrates form at a later stage
  • Waterproof and resistant to frost, all-purpose use
  • Resistant to ageing, insensitive to environmental influences
  • Secure adhesion, bonding with the waterproofing products, e.g. Sikalastic® WP 668
  • Resistant to limewater and chlorinated water
Inquire Now

Contact us if document is not available

Show all documents

Usage

  • For walls and floors
  • For wet areas with non pressurised water, e.g. shower area
  • Suitable to be used in residential buildings, hotels, old peoples homes and hospitals
  • For embedding in the waterproof coatings, e.g. Sikalastic® WP 668
 

Advantages

  • Special polypropylene tape
  • Thin, non-woven, high-tenacity reinforcing tape
  • Crack-bridging, high security when cracks in the substrates form at a later stage
  • Waterproof and resistant to frost, all-purpose use
  • Resistant to ageing, insensitive to environmental influences
  • Secure adhesion, bonding with the waterproofing products, e.g. Sikalastic® WP 668
  • Resistant to limewater and chlorinated water

Packaging

Roll width:

200 mm

Roll length:

50 m

Colour

Grey

Product Details

Product Information

Composition

Polypropylene

Shelf life

24 months from production date

Storage conditions

Store flat in original, unopened and undamaged sealed packaging in dry conditions. Do not expose to direct sunlight or other heat sources.
Technical Information

Elongation at break

Longitudinal

~50 %

Lateral

~50 %

Service temperature

-30°C min. / +90°C max.

 

Application

Application steps

SUBSTRATE PREPARATION

Follow the requirements for substrate preparation of the Sikalastic® WP 668.

APPLICATION

  • In the connection area floor/wall and/or wall/wall apply Sikalastic® WP 668 in a width of approx. 10 - 15 cm by brush or trowel, on each side of the joint (total 20 - 30 cm).
  • Press Sikalastic® WP 668 into the wet waterproofing material. Do not use sharp-edged tools.
  • When applying the waterproofing material to the entire area, insure that SikaCeram® WP Tape is fully covered.
 

Documents