Product Data Sheet Show all documents

Sika® Separol®-202

Oil based, anti-corrosive shutter release agent

Chemical release mould and shutter faces prior to casting concrete in order to achieve a clean release. After removal of the formwork, the resultant concrete has a smooth, hard, uniform finish, with reduced incidence of blow holes.
Low viscosity hydrocarbon carrier blended with a chemically active release agent. Suitable for use in hot and tropical climatic conditions.

▪ Sika® Separol®-202 exhibits a smooth, hard, and uniform finish. ▪ Sika® Separol®-202 has no negative effect on the properties of concrete. ▪ It will not impair the adhesion of subsequent surface treatments when applied at the recommended coverage rates. ▪ Allows clean, easy striking
▪ Extends the life of formwork
▪ Improved finish for fair faced concrete
▪ Reduces concrete contamination
▪ Economical to use
 
Inquire Now
Product Data Sheet Show all documents

Usage

▪ Steel shuttering
▪ Plywood shutters
▪ High density plastic shutters  

Advantages

▪ Sika® Separol®-202 exhibits a smooth, hard, and uniform finish. ▪ Sika® Separol®-202 has no negative effect on the properties of concrete. ▪ It will not impair the adhesion of subsequent surface treatments when applied at the recommended coverage rates. ▪ Allows clean, easy striking
▪ Extends the life of formwork
▪ Improved finish for fair faced concrete
▪ Reduces concrete contamination
▪ Economical to use
 

Packaging

210 L drums

Colour

Clear to brown liquid

Product Details

Product Information

Composition

Blend of oil based products

Shelf life

12 months from date of production if stored properly

Storage conditions

Store in undamaged, unopened, original sealed packaging in dry conditions at temperatures between +5°C and +50°C. Mix well before using.

Density

~0.83 kg/l (+25 °C)

Total chloride ion content

Nil

(EN 934-2)

Application

Consumption

Consumption

The coverage rate for Sika® Separol®-202 is between 30 to 70 m²/L when spray applied depending on the smoothness, type and porosity of the formwork used.
Application steps

APPLICATION

Apply before the first casting and thereafter re-apply immediately after stripping and cleaning the mould.

Shutter surfaces must be clean and free from moisture, dirt and laitance.
Lightweight horticultural sprayers are ideal as Sika® Separol®-202 is finely atomised to give a uniform coating. Excessive application should be avoided.
Alternatively, application may be made by a fine haired brush, only a very thin coating should be made and any excess removed.
If after the first application, the Sika® Separol®-202 is completely absorbed into new timber or plywood, a further application should be made before filling the moulds or formwork.

 

CLEANING OF EQUIPMENT

Sika® Separol®-202 may usually be left in spray guns or sprayers without detriment, but with certain types, there may be some softening of rubber seals with prolonged contact.

Documents