Contact us if document is not available

Show all documents

Sika® Plastocrete®-3701 3D

(former MFlow 3D 240)

A high-performance hybrid polymer for enhancing dispersion and workability retention of Sikacrete®-3701 3D

Sika® Plastocrete®-3701 3D has been developed specifically as an admixture for the Sikacrete®-3701 3D for 3D printing applications. Suitable for use in hot and tropical climatic conditions.

Sika® Plastocrete®-3701 3D allows the following:
  • Production of high early and high ultimate strength elements with minimal voids and therefore optimum density
  • Adjustable workability without segregation or bleeding based on the printing requirements
  • Homogeneous mix and dispersion of the Sikacrete®-3701 3D
  • Improved surface finish
  • 40-60 minutes open time even at high ambient temperatures
Inquire Now

Contact us if document is not available

Show all documents

Usage

The dispersion properties of Sika® Plastocrete®-3701 3D makes it the ideal admixture to be in used with the Sikacrete®-3701 3D for 3D Printing applications.  

Advantages

Sika® Plastocrete®-3701 3D allows the following:
  • Production of high early and high ultimate strength elements with minimal voids and therefore optimum density
  • Adjustable workability without segregation or bleeding based on the printing requirements
  • Homogeneous mix and dispersion of the Sikacrete®-3701 3D
  • Improved surface finish
  • 40-60 minutes open time even at high ambient temperatures

Packaging

25 L pails, 200 L drums upon request

Colour

Clear liquid

Product Details

Sustainability / Certifications / Approvals

CERTIFICATES AND TEST REPORTS

Sika® Plastocrete®-3701 3D follows the requirements of ASTM C494; Type G and EN 934-2
Product Information

Composition

Aqueous solution of modified polycarboxylates, co-polymers

Shelf life

12 months from date of production if stored properly

Storage conditions

Store in undamaged, unopened, original sealed packaging in dry conditions at temperatures between +5°C and +50°C. Mix well before using.

Density

~1.2 kg/l (+25°C)

Total chloride ion content

Nil

(EN 934-2)

 

Application

Application Information

Dispensing

Sika® Plastocrete®-3701 3D is a ready to use admixture that is added to the mixing water for the Sikacrete®-3701 3D at the time of batching.
Sika® Plastocrete®-3701 3D must not be added to the dry materials.
Thorough mixing is essential after the addition of the Sika® Plastocrete®-3701 3D. Mixing time will vary depending on batch size and mixer type until a homogenous consistency is achieved.

Compatibility

Sika® Plastocrete®-3701 3D is not compatible with other superplasticizers and should be used only with Sikacrete®-3701 3D.
Consumption

Recommended dosage

0.06 – 0.1 L / 25 kg of Sikacrete®-3701 3D. Dosages outside this range are permissible subject to trial mixes.

Documents