Sikagard®-65 WN BH

Water-dispersed epoxy resin

12 months from date of production.

Store in unopened, undamaged and sealed original packaging in dry conditions at temperatures between +5 °C and +30 °C. Protect from direct sunlight, heat and moisture.

~1.35 kg/l (at +20°C, mixed A and B)

~56 %

~41 % (theoretical)

Sikagard®-65 WN BH is designed to provide specific chemical resistance to concrete against chlorides and sulphates found in the ground in aggressive environments.

(A : B) = (3 : 1) by weight

<80 %

Beware of condensation!
The substrate must be at least 3 °C above dew point to reduce the risk of condensation or blooming on the surface of the applied product.

+10°C min. / +60°C max.

The substrate can be either dry or matt-damp green concrete and must be cleaned of loose cement particles and all contaminants such as oils, grease, coatings or surface treatments etc..

~60 minutes at +20°C (Caution! End of pot life is not visually noticeable)

Note: at below 80 % r.h.

Min. 2 hous (25°C)

Max. 2 days (25°C)

Note: Apply second coat only after the first coat is tack-free

• The substrate must be sound and of sufficient compressive strength (minimum 25 N/mm2) with a minimum pull off strength of 1.5 N/mm2
• The substrate must be clean, dry and free of all contaminants such as dirt, oil, grease, coatings and surface treatments, etc.
• Concrete substrates must be prepared mechanically to remove cement laitance and achieve an open textured surface.
• Weak concrete must be removed and surface defects such as blow holes and voids must be fully exposed.
• Repairs to the substrate, filling of blowholes / voids and surface levelling must be carried out using appropriate products from the Sikafloor®, Sikadur® and Sikagard® range of materials.
• All dust, loose and friable material must be completely removed from all surfaces before application of the product, preferably by brush or vacuum.

Prior to mixing stir part A mechanically. When all of part B has been added to part A mix continuously for 3 minutes until an uniform mixed has been achieved. Use a low speed electrical stirrer (max. 600 rpm) to avoid air entrapment. To ensure proper mixing pour material into a clean container and stir again.

Sikagard®-65 WN BH may be applied either with a brush, roller or airless spray.

Clean all tools and application equipment with water immediately after use.
Hardened and/or cured material can only be mechanically removed.