Sikafloor® PS

Epoxy resin

24 months from date of production

Store in cool and dry conditions in unopened, undamaged and sealed original packaging at temperatures between +5 °C and +35 °C protected from direct sunlight, heat and moisture.

~1.75 kg/l (mixed resin)

100 %

≥ 1.5 N/mm² (7 d)

Part A : Part B = 2 : 1 by weight

Maximum 3 mm in one single layer.

+5° C min. / +45° C max.

Beware of condensation!

The substrate temparture must be at least 3 ° C above dew piont.

+5° C min. / +45° C max.

~45 min. (+25 °C)*

*200 g

The potlife begins when the resin and hardener are mixed. It is shorter at high temperatures and longer at low temperatures. The greater the quantity mixed, the shorter the potlife. To obtain longer workability at high temperatures, the mixed adhesive may be divided into portions. Another method is to chill components A and B before mixing them (not below +5 °C).

Sikafloor® PS can be over coated with various Sikafloor®, Sikadur® and Sikagard® resins after 12 hours and not later than 24 hours at 30 °C. Sikafloor® PS is fully cured after 7 days. For more details please contact Sika Technical Department.

~ 1.75 kg / m² / mm

This figure is theoretical and does not include for any additional material required due to surface porosity, surface profile, variations in level or wastage etc.

Mix components (A and B) together for at least 3 minutes with a mixing paddle attached to a slow speed electric drill (maximum 400 rpm) until the material becomes smooth in consistency and an even grey colour of the mixture is obtained. Material in industrial packing must be stirred well before proportioning and mixing. Avoid aeration while mixing. Sikafloor® PS is supplied ready for use and only has to be thoroughly stirred.

Sikafloor® PS has easy workability and can be applied by trowel, scraper, or spatula.
 

Clean all equipment and tools with Sika® Colma Cleaner immediately after use. Hardened / cured material can only be removed by mechanical means.