SikaLatex®

SikaLatex® is certified according "Low Emitting Materials as per Al Sa'fat - Dubai Green Building Evaluation System" by Dubai Central Laboratory (DCL) certificate No. CL17020432

Styrene butadiene emulsion

12 months

Store properly in undamaged original sealed packaging, in dry cool conditions at temperatures between 5 °C and 30 °C. Protect from direct sunlight, contamination and moisture.

~1.0 kg/l

≤ 0.1 %

1. Bonding Bridge
Cement : Quartz Sand : Liquid (1 part SikaLatex® + 1 part Water) = 1 : 1 : 1 (by volume) or,
Cement : Quartz Sand : Liquid (1 part SikaLatex® + 1 part Water) = 1.5 : 2 : 1 (by weight)

Apply the slurry by brush onto the pre-wetted substrate in 1-2 mm thickness and apply the subsequent mortar renders immediately (wet on wet application).

2. Repair Mortars

3. Adhesive Mortars

The above mixes are for guidance only and based on the use of sharp, well graded aggregates and dry sand. Trial mixes must be performed to establish the exact dosage rate required. For optimum results, always ensure that the correct SikaLatex® : Water ratio is used. Depending on the application and performance required, Sika Latex® may be added to the clean mixing water within the range of 1:1 to 1:4. For all applications apart from sprayed on renders, a bonding bridge should be brushed into the prepared surface.

Aggregate Grading

Aggregates should be sharp, well and thorougly washed. Sand particle sizes should correspond to the thickness of the applied mortar and to required surface finish.

Mix SikaLatex® with the correct amount of water to produce a gauging solution.

Pour part of the gauging solution into a suitable mixing container. While stirring slowly, add the cement-sand mix to the gauging solution and mix thoroughly until a smooth, uniform and lump-free mix is achieved. Within the mixing time add additional gauging solution to adjust to the desired consistency.