Sikalastic® Fleece-120

System component of following ETAG 005 approvals:

• ETA - 12 / 0308

100 % Polyester

Product does not expire if correctly stored

The product must be stored properly in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +35 °C.

120 g/m²

For detailed information regarding system build-ups, please refer to the System or Product Data Sheet of the Liquid Applied Membrane.

The surface must be sound, of sufficient strength, clean, dry and free of dirt, oil, grease and other contamination. Depending on the material the substrate must be primed or mechanically cleaned. Grinding may be necessary to level the surface. Suitable substrates are such as: concrete, bituminous felts and coatings, metal, brickwork, asbestos cement, ceramic tiles, wooden substrates.

For detailed information regarding substrate preparation and primer chart please refer to the Method Statement of the corresponding Liquid Applied Membrane system

Prior the application of the Sikalastic^® the priming coat if used must have cured tack-free. For the Waiting Time / Overcoating please refer to the Product Data Sheet of the appropriate primer. Damageable areas (handrails etc.) have to be protected with tape or plastic wrapping.

Sikalastic® Fleece-120 is applied in combination with Sikalastic^® Liquid Applied Membrane systems.
1. Apply first coat of of Sikalastic^® Liquid Applied Membrane with a consumption rate according to the Product Data Sheet of the Liquid Applied Membrane. Work only so far in advance that the material stays liquid.
2. Roll in the Sikalastic® Fleece-120 and ensure that there are no bubbles or creases. Overlapping of Sikalastic® Fleece-120 must be minimum 5 centimetre and ensure overlaps are sufficiently wet to bond.
3. The roller may require only a little extra material to remain wet but no further significant material needs to be added at this stage. It is important the fleece does not lift during installation – on some surfaces a spiked roller may assist installation.
4. After the coat is dry enough to walk on, seal the roof area with second coat of Sikalastic^® Liquid Applied Membrane with a consumption rate according to the Product Data Sheet of the Liquid Applied Membrane.

Please note, always begin with details prior starting with waterproofing the horizontal surface. For details follow step 1 − 3.

For detailed application information please refer to the Method Statement of the corresponding Liquid Applied Membrane system.