Sikalastic® M 266 R ME

12 months from date of production

Store in undamaged, unopened, original sealed packaging in dry conditions at temperatures between +5°C and +35°C. Protect from direct sunlight, heat and moisture.

≥ 90 %

Note: For the primer consumption rates and waiting time / overcoating, refer to the appropriate Product Data Sheet. Other substrates must be tested for their compatibility. If in a doubt, apply a test area first.

• Where a superior performance is required the material can be reinforced with a layer of suitable mesh. Each coat encapsulating the mesh should be min. 1 mm thickness.
• All liquid applications should be applied in at least two coats to achieve the desired thickness.
• Please contact Sika Technical Services Department for assistance. 

Impermeable (tested at 0.3MPa/30 min.)

Min. 1.2 mm

+5°C min. / +40°C max.

~50 min at 25°C

~8 hours at 25°C

~24 hours at 25°C

One 28 kg kit should cover ~16 m² for a 1.2 mm Dry Film Thickness (DFT).

This figure is theoretical and does not allow for any additional material due to surface porosity, surface profile, variations in level and wastage etc.

~21.6 L / 28 kg kit

The substrate should be smooth, clean, and free of laitance, grease, oils and standing water.
Repairs to the substrate, filling of joints, blowholes/voids and surface leveling must be carried out using the appropriate Sika® products. Refer to Sika’s Technical Department for further advice.

• Mix using an electric single or double paddle mixer and stirrer (300–400 rpm) or other similar equip-ment.
• The mixing should be carried out in a separate container.
• Part B should be poured in the separate container and Part A should be added while stirring/agitating the Part B.
• Mix Part A + B continuously for 2 minutes until a uniformly coloured mix has been achieved.

• Strictly follow installation procedures as defined in method statements, application manuals and working instructions which must always be adjusted to the actual site conditions.

Clean all tools and application equipment with Thinner C after use. Hardened material can only be removed mechanically.