Sika® Primer-117 MS

Epoxy

12 months from date of production

The Product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +15 °C and +25 °C. Always refer to the packaging.

Refer to the current Safety Data Sheet for information on safe handling and storage.

40 %

100 : 66 by weight

1 hour to maximum 6 hours

The substrate temperature must be at least +3 °C above dew point to reduce the risk of condensation decreasing adhesion.

Minimum 1 hour

For 15 mm deep joints (2x 15 mm adhesion area): ~6 ml/m or ~200ml/m²

Note: Consumption data is theoretical and does not allow for any additional material due to surface porosity, surface profile, variations in level, wastage or any other variations. Apply the Product to a test area to calculate the exact consumption for the specific substrate conditions and proposed application equipment.

Substrate must be sound, clean and free of all contaminants such as dirt, oil, grease, polish, coatings, water-soluble and water-resistant adhesives, varnish, laitance, surface treatments and loose friable materials.

1. Empty the entire content of part B into the container holding part A.
2. Use a hand-held stirrer to mix part A and part B for at least one minute or until a homogeneous mixture is achieved, ensuring there are no residues left.
3. Close the container tightly.
4. Use all mixed material after mixing, within six hours at 23 °C . During this time, the consumption might increase due to increasing viscosity. Note The appearance of the Product does not change, even if it is no longer suitable for application.

1. Use a brush to generously apply the primer to the adhesion surfaces intended for the joint sealing material.
2. To ensure full curing, maintain the material and the substrate temperatures above the minimum limit at any location and at any point during the curing time.
3. Apply the joint sealant within the specified open time.
4. If the 6-hour limit is exceeded, re-prime the coated surfaces using . Ensure that the surfaces to be re-primed are clean and free from dust.

Clean all tools and application equipment immediately after use with Sika® Remover-208 or Sika® PowerClean. Once cured, hardened material can only be removed mechanically.