Sika® Igolflex®-365 GCC

Blend of bitumen and rubber

12 months from production date when stored properly in original unopened containers.

Store in in original, unopened and undamaged sealed containers in a cool, dry area under shade temperatures between +5 °C and +35 °C.

~1.01 kg/l (+25 °C)

10 - 11

Groundwater, salt solutions, sea water, mild detergents, mild acids and alkalis. Contact Sika Technical Department for further information.

+5 °C min. / +45 °C max.

+5 °C min. / +55 °C max.

 ~4 h (+35 °C)

Minimum 6 h (+35 °C)

0.25 - 0.40 kg/m² per coat, apply 2 - 3 coats
This figure is theoretical and does not include for any additional material required due to surface porosity, surface profile, variations in level and
wastage etc.

All surfaces must be sound, even, free from dust, loose particles and any contamination. May be applied to damp but not waterlogged surfaces.

Hot and very dry, porous concrete surfaces must be primed by diluting Sika® Igolflex®-365 GCC with clean water at 1 : 1 ratio (by weight).
When used as protective coating, all pinholes, cavities, cracks etc. in the substrate must be filled with a suitable Sika® repair mortar.

Sika® Igolflex®-365 GCC must be stirred well before use. Where a single drum is used for prolonged periods, occasional stirring during application is recommended.

If a primer coat is applied, allow it to dry before applying subsequent coats.
Apply evenly and in one direction using a brush or roller. A two-coat application is recommended to avoid possible pinholes in the membrane.
Each coat must be allowed to dry before applying the next one.
Protect freshly applied product from rain until it is fully cured.

Clean all equipment and tools with water immediately after use. Dampen tools before and occasionally during use to avoid clogging and ease of application.